You are currently viewing How To Reset Oil Change On Jeep Grand Cherokee

How To Reset Oil Change On Jeep Grand Cherokee

  • Post author:
  • Post category:cloud
  • Post comments:0 Comments

How To Reset Oil Change On Jeep Grand Cherokee. Watch the oil change or maintenance light carefully. It will begin to blink.

Jeep Wrangler 3.6L Pentastar Engine Oil Change 2012, 13
Jeep Wrangler 3.6L Pentastar Engine Oil Change 2012, 13 from toxiccrush.com

Now you are going to hold down the ok button until you see that the oil life display has changed to 100 percent. Press the step button and reset the mileage till next service. Immediately press and release the accelerator pedal 3 times within 10 seconds.

Press the ignition start button to run.

It should start to blink. Push and hold the ok button until the oil light percentage changes to 100%. 2) wait for the the yellow oil change warning to appear 3) press accelerator three times before the warning goes away.

Turn the ignition back to the on position while holding the reset button.

Yes it probably will be the sender. If the indicator message still illuminates when you start the car, the oil change indicator system did not reset, and you will need to repeat this procedure. Set the gear to park position.

Turn off the ignition and start the engine to make sure it worked.

Without starting the engine, turn the ignition in the on/run mode position. Jeep grand cherokee oil service maintenance reminder light. Oil change light reset jeep cherokee 2015.

If it is not reset the system will be unable to properly track when your next oil change is due.

It will begin to blink. Apart from using the gas pedal, you can also access the oil life menu to reset the oil light on the 2016 grand cherokee or later. How to reset oil life on jeep grand cherokee 2004.

Check the oil change or maintenance light closely.

The oil change light reset jeep cherokee 2015 will need to be performed after every oil change. 1) press ignition button twice to run do not start. Turn the ignition to the run position.

Leave a Reply