How To Measure Torque Converter Bolt Pattern

How To Measure Torque Converter Bolt Pattern. Measure the distance from the outside of one stud to the inside of the opposite stud on the conerter. Please click accept cookies to continue to use the site.

29/32 x 29/32 Bolt Holes 550 lb Capacity Range 27/8
29/32 x 29/32 Bolt Holes 550 lb Capacity Range 27/8 from novotekmanpower.rs

The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Measure the distance from the outside of one stud to the inside of the opposite stud on the conerter. Tighten the bolt further to determine the applied torque.

Please click accept cookies to continue to use the site.

So, if the distance is 5.75 inches x 2 = 11.5 inches. As bill eccles of bolt science writes, there are three ways this can be achieved: 3 bolt hole with a 9 3/8 center hole.

In your situation it will probably end up as 10 7/16 or so which is the 10.5 pattern

Measure the distance from the outside of one stud to the inside of the opposite stud on the conerter. Skipping a bolt hole in between. Tighten converter nuts and measure again.

Bolt circle dims how to measure wheel bolt patterns wild horses off road technical support how to calculate bolt circle diameter bcd for chainrings and bash guards owlcation bolt circle diameter calculator electricscooterparts how.

For example, the 10 converter in my race car measures around 10 5/8 at its largest point.the 8 coverter i ran in the past measured 8 3/4. Tighten the bolt further to determine the applied torque. If you can remove the inspection cover on the bottom of the trans, rotate the flexplate so two of the converter bolts are accessable.

Verify that the torque converter bolt pattern matches the flexplate bolt pattern.

To determine your torque converter bolt pattern, measure from the crank centerline to the centerline of one converter bolt hole and multiply by 2. The torque converter bolt pattern is 10, it's 13 in diameter. How to measure torque on a bolt.

I usually will use a locking device even if the mfg doesn't.

6 bolt with a 10 center hole. Measure the distance between them, the 10 1/2 pattern should be 7 1/2 inches center to center and the 11 7/16 pattern should be 8in center to center. Read the torque when the bolt starts moving again.

Leave a Comment

Your email address will not be published. Required fields are marked *