### How To Bridge An Amp To 2 Ohms

**How To Bridge An Amp To 2 Ohms**. A 2 ohm bridged mono load will more than likely destroy the amplifier. The rms is 200w, and the max is 600w for each sub.

For this amp the sub channel is good down to 2 ohms and same with the four channel section. Two 2 ohm woofers connected in series (2 + 2 = 4 ohms) for an amp that requires a 2 ohm load minimum when bridged use: To bridge an amp you are putting two channels into one.

Table of Contents

### If the speakers are 8 ohms each and are wired in parallel then the amp is seeing a 4 ohm load and each speaker is potentially getting 1/2 of the 4 ohm bridge rated power of the amp, which is likely somewhere between 500w and 1,000w per speaker.

Unless stated otherwise, this amp would be unstable below 2 ohms stereo or 4 ohms mono bridged. Continuous watts per channel (4 ohms) 220 x 1 continuous watts per channel (2 ohms) 400 x 1 continuous watts bridged 600 max power watts per channel (4 ohms) 220 x 1 max power watts per channel (2 ohms) 400 x 1 max power watts. For dvc sub, the wiring is basicly like 2 svc sub for each driver/speaker.

### How do you find your minimum speaker load (ohms)?

Doing so with an xti is asking far more of the design than it is likely capable of if you expect the amp to have a long life. You can also reduce the ohms further. Another interesting consequence of bridging is that the amplifier damping factor is cut in half when you bridge.

### Take one negative to one positive on each sub.

To bridge and run under 4 ohms is stupid, period. For an example, a 100 watt per channel at 4 ohms amp may put. You can bridge your amp and run the speaker wires in a circuit and it will drop it down to one ohm.

### This is a simple, and requires no image.

Bridging the amps does not change the z of the speakers, nor impact the amps ability to drive it. Two 2 ohm woofers connected in series (2 + 2 = 4 ohms) for an amp that requires a 2 ohm load minimum when bridged use: Generally, if you use an 8 ohm speaker, and the amplifier is a good amp for driving 4 ohm speakers, it will behave well bridging.

### All decent amps can handle 4 ohms.

Learn how to wire a dual 2 ohm car subwoofer to a 1 ohm final impedance using the parallel wiring method.the most common question we are asked here at sonic. So, when you bridge your amplifier, you're also optimizing your system's power potential. So you're trying to say you want to bridge the front channels but still use the rear channels?